Macro Problem

[jeanp]

Hello
Apparently when requesting an IP command in a macros this does not work ...
In the example below, the IR TV 4K Samsung St-by command by the New Centro-8M 1 is executed but not the IP command inter1_on by Domoticz.
I specify that this IP Domoticz command works off macros.
Do you have an idea ?
Excuse me for my English..

Sans titre-5.png

Sans titre-2.png

Sans titre-1.png

[DemoPad]

I assume you have tested the IP command from the 'Test Command' option of pre-defined commands, and it works from there?

It looks like you have set it up correctly - please make sure you do an upload to the Centro after making any changes to the macro, or the 'link to processor' option which you have correctly chosen.