Pioneer AVR IP Control and Feedback

Forum to ask for any help
Post Reply
nealconyard
Posts: 6
Joined: Mon Dec 01, 2014 8:47 pm

Pioneer AVR IP Control and Feedback

Post by nealconyard » Sun Jan 18, 2015 6:52 pm

I've asked this question in another thread however it probably bests sits in its own thread for those out there who use Pioneer kit.

Basically I'm looking to build a function on my remote that will set a volume control subpage to enable me to control sound levels on either my TV (or later projector) or my PIONEER SC2025 AVR. I have the IP commands from Pioneer for the AVR which I am using to send commands but am a bit like a fish out of water when it comes to retrieving 2-way feedback data.


The way I'm thinking of doing it it to have a flag set that if the feedback from the AVR power state indicates that it is switched on it activates a subpage which uses the AVR volume controls and if it is set to off it instead uses the TV/Projector volume controls.

The question I have to ask is how do I set the app to listen for the power state feed back?

I know I need to send the AVR the command ?P and then receive the following commands:

pwr0 = on
pwr1 = off

depending on the power state.

Can someone tell me how I go about polling the AVR to query the power state and then use it to add a label based on the power state

starwarsmike
Posts: 146
Joined: Mon May 13, 2013 12:48 pm

Re: Pioneer AVR IP Control and Feedback

Post by starwarsmike » Sun Jan 18, 2015 8:28 pm

Hi

Please email me, I'll email you Pioneer DC1 & 2 commands & protocol document.

murphy-michael3@sky.com

nealconyard
Posts: 6
Joined: Mon Dec 01, 2014 8:47 pm

Re: Pioneer AVR IP Control and Feedback

Post by nealconyard » Sun Jan 18, 2015 9:26 pm

Thank you. Email sent

User avatar
Cheesegeezer
Posts: 47
Joined: Wed Mar 02, 2016 10:15 pm
Location: On an oil rig somewhere

Re: Pioneer AVR IP Control and Feedback

Post by Cheesegeezer » Tue Jan 31, 2017 12:00 am

starwarsmike wrote:Hi

Please email me, I'll email you Pioneer DC1 & 2 commands & protocol document.

murphy-michael3@sky.com
I have sent you one too Mike.

Thanks

Post Reply