Using Centro IR outputs with Wyrestorm Matrices
Posted: Wed Jul 02, 2014 4:07 pm
If you need to connect the IR output of a Centro processor to a Wyrestorm matrix for transmission of the IR through the HDMI balun system, you cannot use the stereo-stereo cables which are supplied with the Centro.
Both the Centro IR outputs, and the Wyrestorm IR inputs have stereo sockets with 3 pins:
TIP: Pin1
RING: Pin2
SLEEVE: Pin3
At the Centro end, the pins required are the tip & the ring pins 1 & 2.
At the Wyrestorm IR RX end, the pins required are the ring and the sleeve pins 2 & 3.
Connect the Centro Pin1 to Wyrestorm Pin2, and connect Centro Pin2 to Wyrestorm Pin3. Connect nothing to Pin1 of the Wyrestorm plug.
Both the Centro IR outputs, and the Wyrestorm IR inputs have stereo sockets with 3 pins:
TIP: Pin1
RING: Pin2
SLEEVE: Pin3
At the Centro end, the pins required are the tip & the ring pins 1 & 2.
At the Wyrestorm IR RX end, the pins required are the ring and the sleeve pins 2 & 3.
Connect the Centro Pin1 to Wyrestorm Pin2, and connect Centro Pin2 to Wyrestorm Pin3. Connect nothing to Pin1 of the Wyrestorm plug.