Sharp Smart TV IP commands 140420

[cv27]

Two files attached:
1- "Sharp Smart TV IP commands - documentation 140420.docx.txt" - it's actually a Word file, so remove the trailing ".txt"
2- "Sharp Smart TV IP codes 140420.dc1"

These codes are taken from the Sharp manual, but the format of this documentation is easier to use in my opinion.

Notes:
- Command names preceeded with an asterisk need the code to be tweaked; they require most likely a variable (ex: volume) to replace the asterisk in the code
- The following commands, although not returning an error code (ERR), don't display the information as they should (underscores to be replaced with spaces):
Device Name: TVNM1___
Model Name: MNRD1___
Software Version: SWVN1___
IP Protocol Version: IPPV1___

I personally switch all A+V through my Amplifier and feed only to HDMI-1 of the TV set. Most of these codes have been tested on a Sharp LC80LE642U, but should work on most Sharp Smart TV's. Many commands I have not tested pertain to "over the air" cable, some exotic function (ex: position) or functions I don't need because of my setup.