Virgin V+ HD IP or IR Codes

[Baljy74]

Hi,

i urgently require Virgin V+ HD IR or IP cmds please. I am not sure if IP is available for this model.

Looked everywhere on remotecentral as well but no luck.

Thanks!

Balj.
iSmart Home Control.

[DemoPad]

Try these - they are toggle codes, so you need to alternate the 'A' and 'B' versions of the codes, or send both...

[Baljy74]

Thanks!

[redjoe100]

Hello, I am trying to control my Virgin V+ HD box via IR. This is the box I have....
http://www.trustedreviews.com/news/Virg ... s-V-HD-Box
I am using the codes in the above post, If I send the A & B versions (for the same button), some times the command operates twice, sometimes once, some buttons are different, it seems to be random. If I take away the B version, then the command operates but then as soon as I press the button again it doesn't respond (the IT emitter does flash). If I wait about 20 seconds it will then start to operate again. Am I doing something wrong or do I have the wrong codes? Thank you

[DemoPad]

You need to alternate 'A' and 'B' codes. Have a flag called 'USECODEA' or something, and in your actions for the button:

1. Toggle the flag 'USECODEA'
2. Send the 'A' code, dependent on the 'USECODEA' flag being ON
3. Send the 'B' code, dependent on the 'USECODEA' flag being OFF

Either steps 1 & 2 will occur, or steps 1 & 3, and it will change each time you press a button (because each button toggles the flag). Use the same flag for each button in your remote control page.

[Pasika]

Hi there,
Am finding myself in the same situation mentioned above.
Where and how would I create the action relating to toggling the commands?

Thanks
Rom Pasika