Onkyo IP Commands

[member_c837]

IP Commands for Onkyo - keep default command suffix of \x0D\x0A, non-UDP. **Updated 6 May 2013**

[RedwingSystems]

Thanks for posting the Commands. What Port and Command Suffix do you use as I'm struggling to get this is work?

Cheers

[DemoPad]

You need to enable network control in the settings for the amp, the port is configurable there. The default suffix of \x0D\x0A works.

[RedwingSystems]

Many thanks

[flinke flasche]

Hi,

i have the NR717 Receiver.
Many Commands are not listed like BD Source or Ch+, Ch-.

Has anyone all IP Commands for the newer Models of Onkyo?

Tobias

[sonnyjimspencer]

Do you know the default port number for the device as my commands do not seem to be working? :/

[DemoPad]

Think default port is 60000/60128, but it can be set from the menu. Think you also need to enable remote control via IP in there as well.

[sonnyjimspencer]

It still doesnt seem to work. I have set a static ip address up on the onkyo device but cant see an option for the port settings. Is this ip control compatiable with the 414 model?

[DemoPad]

Onkyo provide a free app to control the 414 - suggest downloading that first & making sure it works through there. The 414 does allow IP commands. You can email support@demopad.com for the protocol document, but I believe the commands are the same as those posted here.

[flinke flasche]

The default Port is 60128.

I got a newer IP List from Onkyo for newer models like my NR717.
I must promise to do not release the list I dont know why?

[sonnyjimspencer]

Yes I had to use the new port number thank you. The original commands still work fine

[DemoPad]

Command file above updated to include all the commands, courtesy of a DemoPad forum member - many thanks.

[Steve_Jones]

Having some trouble getting even a simple "on" or "off" button to work Tx-NR 515,

Ive checked the Amp has an IP address which can be pinged, I have downloaded the command list at the start of this topic..

When I run the Test it says "Command Sent"

This is the string I am using

ISCP\x00\x00\x00\x10\x00\x00\x00\x08\x01\x00\x00\x00!1PWR01\x0D

The device is on port 60128 with UDP ticked,

The Amp works on the Onkyo remote on my HTC..

Any ideas, bit of a noob at all this here

thanks

steve

[Steve_Jones]

Thanks for the commands, work a treat ..

[tgatlinjr]

Having some trouble getting even a simple "on" or "off" button to work Tx-NR 515,

Ive checked the Amp has an IP address which can be pinged, I have downloaded the command list at the start of this topic..

When I run the Test it says "Command Sent"

This is the string I am using

ISCP\x00\x00\x00\x10\x00\x00\x00\x08\x01\x00\x00\x00!1PWR01\x0D

The device is on port 60128 with UDP ticked,

The Amp works on the Onkyo remote on my HTC..

Any ideas, bit of a noob at all this here

thanks

steve

Hi -

This is the string I am using on my Onkyo TX-NR1008 -

ISCP\x00\x00\x00\x10\x00\x00\x00\x08\x01\x00\x00\x00!1PWR01\x0D and it works fine.

I believe the UDP should NOT be ticked.