DemoPad.com

Posted: **Tue Mar 07, 2017 12:19 am**

Hello
Apparently when requesting an IP command in a macros this does not work ...
In the example below, the IR TV 4K Samsung St-by command by the New Centro-8M 1 is executed but not the IP command inter1_on by Domoticz.
I specify that this IP Domoticz command works off macros.
Do you have an idea ?
Excuse me for my English..

Sans titre-5.png

Sans titre-2.png

Sans titre-1.png

Posted: **Thu Mar 09, 2017 4:37 pm**

I assume you have tested the IP command from the 'Test Command' option of pre-defined commands, and it works from there?

It looks like you have set it up correctly - please make sure you do an upload to the Centro after making any changes to the macro, or the 'link to processor' option which you have correctly chosen.

DemoPad.com

Macro Problem

Macro Problem

Re: Macro Problem