Macro Problem

Forum to ask for any help
Post Reply
User avatar
jeanp
Posts: 2
Joined: Wed Sep 19, 2012 8:04 pm
Location: Switzerland
Contact:

Macro Problem

Post by jeanp » Tue Mar 07, 2017 12:19 am

Hello
Apparently when requesting an IP command in a macros this does not work ...
In the example below, the IR TV 4K Samsung St-by command by the New Centro-8M 1 is executed but not the IP command inter1_on by Domoticz.
I specify that this IP Domoticz command works off macros.
Do you have an idea ?
Excuse me for my English..
Sans titre-5.png
Sans titre-2.png
Sans titre-1.png
You do not have the required permissions to view the files attached to this post.

User avatar
DemoPad
Site Admin
Posts: 734
Joined: Thu Jun 14, 2012 10:46 am
Contact:

Re: Macro Problem

Post by DemoPad » Thu Mar 09, 2017 4:37 pm

I assume you have tested the IP command from the 'Test Command' option of pre-defined commands, and it works from there?

It looks like you have set it up correctly - please make sure you do an upload to the Centro after making any changes to the macro, or the 'link to processor' option which you have correctly chosen.

Post Reply