How to get started...

Forum to ask for any help
Post Reply
Guus
Posts: 3
Joined: Sat Dec 13, 2014 10:40 am

How to get started...

Post by Guus » Mon Dec 22, 2014 12:36 am

Hi all,

I need a little hand to know Demopad.

Perhaps i thinking to difficult but i'am stuck. I followed some tuturials, wich show's me how to set up "devices" and commands.
Now,
I have a Global Cache module IP/IR with 3 outputs.

Do i need to configure one component (TV or receiver etc..) per output ?
Demopad.JPG
How does the filestructure working ?
Why does they have different map symbols for source (see the yellow highlight)
Sorry folks, i'am confused, try to figure out....


Many thans in advance !

Guus.
You do not have the required permissions to view the files attached to this post.

User avatar
DemoPad
Site Admin
Posts: 750
Joined: Thu Jun 14, 2012 10:46 am
Contact:

Re: How to get started...

Post by DemoPad » Tue Dec 23, 2014 10:59 am

A device in the software is a network destination, eg if you have an IP2IR working on port 4998 - that is one device. You don't need to add a device for each component it is controlling (TV, DVD etc) - they should be folders of commands within the device.

Sub pages are smaller areas of a page which can be placed on a main page - useful for bringing on remote controls etc, and they can be used across several pages. Subpages have the yellow icon.

The file structure in terms of pages / subpages is entirely decided by you - you add as many pages / sub pages as you need and program how to navigate between them using page jump actions.

Hope this helps...

Guus
Posts: 3
Joined: Sat Dec 13, 2014 10:40 am

Re: How to get started...

Post by Guus » Tue Dec 23, 2014 3:42 pm

Yes,

This works !

Thanks for helping.

Post Reply