Page 1 of 1

Aviosys 9100a Web server

Posted: Tue Apr 15, 2014 5:10 pm
by starwarsmike
Hi, need some help.

I have setup Aviosys 9100a, create a Dynamic Label. Now my problem is the picture just flashes on & off, so I thought, it must be the refresh rate in DemoPad, but it wasn't. I went to setting on the Device by typing in the IP address on my PC, & it also shows a flashing image of my Sky Picture. Checked all the connections but no joy.

Does anyone have any ideas?,

I have a Sky DRX895 box
I connect a RCA phono to phono cable (composite video signal)(yellow connection
I also have my box connected to Hdmi

???

Help much appreciated

Re: Aviosys 9100a Web server

Posted: Fri Apr 18, 2014 9:16 am
by asimp11
You can full reset the 9100a, make sure your router is on the same subnet. But is is more likely the sky box these can be glitchy at best. Perform a hard boot on your sky box to be sure, Simply - hold down the backup button for 20 second whilst removing then replacing the power lead at back when four lights appear on the front panel release the backup button. Good luck. T

Re: Aviosys 9100a Web server

Posted: Sat Apr 19, 2014 4:13 pm
by tytherman
Are you using the stock firmware that comes with the unit? I use mine for CCTV and had flashing image before updating the firmware.

Re: Aviosys 9100a Web server

Posted: Sun Apr 20, 2014 3:26 pm
by starwarsmike
Cheers Guys, got it working using both you're suggestions.

Much appreciated

Michael