Page 1 of 1
Demopad running on more than one device
Posted: Thu Feb 06, 2014 3:30 pm
by Neilpapworth
I have a Wyrestorm 6x6 Matrix, which I control over TCP/IP.
I can get 2 way feedback working if I set the device to "Maintain Active Connection" but potentially I have three IPad's trying to control this device and that requires I set "Disconnect after each command." Is there any way out of this impasse?
Re: Demopad running on more than one device
Posted: Tue Feb 11, 2014 10:52 pm
by DemoPad
Our Centro 8 processor deals with this - by establishing a single connection & all iPads connect to the Centro.
You can try manually using the connect/disconnect from device to let each iPad periodically 'log in' to the matrix & get feedback, and then disconnect to let others try....
Re: Demopad running on more than one device
Posted: Wed Feb 12, 2014 12:23 pm
by d_hero
Ive asked before but is there anyway at all to get hold of the Centro 8 processor and software with out being a Pro installer/company?
Re: Demopad running on more than one device
Posted: Fri Feb 28, 2014 12:44 pm
by d_hero
d_hero wrote:Ive asked before but is there anyway at all to get hold of the Centro 8 processor and software with out being a Pro installer/company?
Just wondered if there was a reply to this at all?
Thanks