DemoPad.com

Hi,

Just wondered if anyone has this working? Mainly the volume slider. It had a look at the Yamaha example and didn't know where to start..

Thank You

Yes I do.
Will post instructions later today.

Brilliant, thank you. I have the Denon set as a device and can send commands. just trying to set the feedback up..

Thanks in advance

OK
First thing you need to do is create a Master Volume Project Number.
Lets say you name the Project Number "Num_Master_Vol"
Set minimum to 0 and Maximum to 100, set default to whatever you want I use 20.
Create a custom action for the number with a minimum of 0 and a maximum of 100
add any Denon action for now we will change later.

Now setup a master vol command for the Denon i.e.
Denon_Main Vol the command data for it would be
MV[Num_Master_Vol]

Now setup a fedback to load the Num_Master_Vol project Number i.e FB_Master_Vol
Condition Type feedback matches pattern send data to a number
Data = MV([0-9a].)
select the Num_Master_Vol project number from drop down list.

Now change the dummy action in the Main_Vol Number to the master vol command you created.

Set your gauge to the Num_Master_Vol.

Now when you move your gauge the Denon Volume will change and the gauge will show the setting.

I suggest doing Volume query when you enter the page to set the gauge first.

Hope this helps.

Hi,

Thanks for that, I tried to get this setup however I got lost and couldn't get it to work. Not sure where I have gone wrong so can't really ask for more help. I set up the gauge and I believe the rest is correct. I'll investigate some more.

cheers

Not sure if this could be the cause, but go into the Denon Web Interface (just type http:// ip address).
Then go to setup menu, then Audio and set scale to 0-98.
You need to be using the full json api not the http version of Denon control. (the published Denon api)
Other than that instructions should work.

Hey,

Got it working! Thank you soo much!

Cheers