Page 1 of 1
Optoma projector
Posted: Sun Nov 18, 2012 12:10 am
by Nnuudd
I have a optoma projector and control it with wifi to ir. works fine, all but power off. Power off is very hit and miss and seem I have to press it so many times to get it to work. I have tried to repeat the command over and over but does not always work.
Anyone else had this problem?
Re: Optoma projector
Posted: Sun Nov 18, 2012 11:35 am
by dansonamission
Have you tried learning the IR command for off again?
Re: Optoma projector
Posted: Sun Nov 18, 2012 4:14 pm
by Nnuudd
yh i tried that but still no luck
Re: Optoma projector
Posted: Tue Nov 20, 2012 7:32 am
by Idealhomes
How does it perform with power toggle on/off? Maybe you could use discrete on for "on" and power toggle for "off".
Re: Optoma projector
Posted: Sun Jan 13, 2013 2:43 pm
by dasmith83
I have a HD700x and the standard remote requires the off button to be pressed twice for it to turn off anyway...so on my set up, i just send 1 IR signal, followed by another 3 seconds later and it powers off everytime no problem. I'm using the IP2IR and the IR blaster rather than the smaller transmittors