DemoPad.com

Have two of them but unfortunately haven't had the time to try them out. Hoping to over the holidays. Thanks

Charles wrote:Commands for Pioneer AV Receiver VSX Series

Was this IP or IR commands ?

Thanks

Thanks

I ordered two from your link.

Is there any complicated setup for it to work with demopad or is it a case of adding the IP and port and it just works.

Thanks again for the advice

So do you think then any rs-232 to IP/Ethernet adapter will work like these on ebay because some are about £20+


Item number: 300806072996
Item number: 260947902733
Item number: 290687247220

Thanks

I would love Rako lighting but far to expensive for my budget just yet. Any thoughts on LightwaveRF or Z-Wave etc for controlling lighting via DemoPad ? The lightwaveRF does look nice and cheap but no two way control/feedback. Also adding a Heating system is on the cards too. Something where ti work...

Hi Looking at the Rako system and noticing that there are several different Bridges that you can purchase. Can someone advise which one I need or which does what. I want to use it with DemoPad on my Ipad2. I have Cat5e running to most of my house and Wifi on 5ghz if that helps. Would also like most ...

Look at lightwaveRF or Siemens RF in B&Q, its the same thing. Control box £70, single gang dimmer £25, works great from my iphone and ipad using demopad, works with sliders too! Only downside, it doesnt have feed back but if your in the room you can see if the light is on :) Hi, What does the comma...

Hi just wondering if the TW6000 can or not be controlled via IP Network instead of the inbuilt RS232 port. I only ask as there is a Cat5/network port used for the external IR blaster. So maybe just maybe it is possible

Any one have these? Im looking but have no joy as yet?

thanks

Here are most of the main commands which work for me. There are more if you look online.

dansonamission wrote:Is there any feedback for a sonos zone, such as the volume?

I think Sonos only allow a very limited amount of control but if you do find out if this is possible or not do share

DemoPad wrote:port 1400, command suffix \x0D\x0A, don't tick UDP, click 'disconnect after each command'. The IP address you specify is the one to which commands are sent, so if you have 2 zones, you'll need 2 devices.

It works! many thanks. soooo much easier when someone tells you how to do it

thank you

Nice

Can't afford those for the mo so just in need of a cheaper confirmed working IP to rs232 solution.